Center Pillar Upper Garnish Molding Replacement

WARNING: This page does not describe the selected car, but rather 8 other vehicles, including the 2011 GMC Yukon XL, 2011 GMC Yukon, 2011 Chevrolet Tahoe, 2011 Chevrolet Suburban, and 2011 Chevrolet Avalanche. However, it is still accessible from the selected car via links, so may be relevant.

Fig 1: Center Pillar Upper Garnish Molding

Courtesy of GENERAL MOTORS CORP.

Callout	Component Name
Preliminary Procedures Disable roof rail SIR system. Refer to SIR Disabling and Enabling . Remove center pillar lower garnish molding. Refer to Center Pillar Lower Garnish Molding Replacement .
1	Center Pillar Upper Garnish Molding Cover
2	Center Pillar Upper Garnish Molding Screw CAUTION: Refer to Fastener Caution . Tighten 2 N.m (18 lb in)
3	Center Pillar Upper Garnish Molding Assembly Remove seat belt D-ring from the adjuster assembly. Pull garnish molding toward inside of the vehicle to disengage the retainers. Align 4-way locator to center pillar before engaging retainers. Tighten 35 N.m (25 lb ft)
4	Center Pillar Upper Garnish Molding Retainer (Qty: 4)