LEMON Manuals: Even more car manuals for everyone
Home >> Chevrolet >> 2012 >> Volt L4-1.4L Elect >> Repair and Diagnosis >> Starting and Charging >> Power and Ground Distribution >> Auxiliary Power Outlet >> Diagrams >> Diagnostic Aids >> General Electrical Diagnostic Procedures >> Circuit Testing >> Using Fused Jumper Wires

Using Fused Jumper Wires




Using Fused Jumper Wires

Special Tools

EL 35616-20F - Fused Jumper Wire

For equivalent regional tools, refer to Special Tools Tools and Equipment.

Danger: This procedure should not be performed on high voltage circuits. Performing this procedure on high voltage circuits may result in serious injury or death.


Note: A fused jumper may not protect solid state components from being damaged.





The EL 35616-20F - Fused Jumper Wire includes banana jack connectors that provide adaptation to most connectors without damage. This fused jumper wire is supplied with a 20 A fuse which may not be suitable for some circuits. Do not use a fuse with a higher rating than the fuse that protects the circuit being tested.

scientia non olet · About LEMON Manuals