Radiator Inlet Hose Replacement (Non-HP2)
WARNING: This page is about a different variant/trim than selected.
Courtesy of GENERAL MOTORS COMPANY Radiator Inlet Hose Replacement (Non-HP2)
| Callout |
Component Name |
|
Preliminary Procedure
- Drain the cooling system. Refer to Cooling System Draining and Filling (Static Fill) .
- Remove the air cleaner outlet duct. Refer to Air Cleaner Resonator Outlet Duct Replacement
.
|
| 1 |
Radiator Inlet Hose
- Remove the radiator vent hose from the radiator inlet hose clips.
- Using J 38185
hose clamp pliers, reposition the radiator inlet hose clamps.
Special Tools
J 38185
Hose Clamp Pliers |