Fluid Pump Cover Installation

WARNING: This page is about a different car, the 2007 GMC Sierra and 2007 Chevrolet Silverado. However, it is still accessible from the selected car via links, so may be relevant.

Fig 1: View Of Fluid Pump Cover Assembly, Cover Bolt Tightening Sequence, 1-2-3-4 & 3-5 Reverse Clutch Housing Thrust Washer & Alignment Tool

Courtesy of GENERAL MOTORS CORP.

Callout	Component Name
1	Fluid Pump Cover Assembly
2	Fluid Pump Cover Bolts M6 x 40 (Qty: 13) Tip: Hand tighten only.
3	Alignment Tool and Bolt NOTE: Refer to Fastener Notice . Procedure Center the J 46664 around the fluid pump cover assembly in the 9 o'clock position and tighten the alignment bolt. See Special Tools . Tighten the fluid pump cover bolts in the sequence shown. Tighten: 11 N.m (97 lb in) Special Tool: J 46664 Pump Cover Alignment Tool. See Special Tools .
4	NEW 1-2-3-4 and 3-5 Reverse Clutch Housing Thrust Washer