Fluid Pump Cover Cleaning and Inspection
WARNING: This page is about a different car, the 2007 GMC Sierra and 2007 Chevrolet Silverado. However, it is still accessible from the selected car via links, so may be relevant.
Fluid Pump Cover Cleaning and Inspection
| Callout | Component Name |
|---|---|
|
CAUTION:
Valve springs can be tightly compressed. Use care when removing retainers and plugs. Personal injury could result. Preliminary Procedure: Clean and inspect all components and machined surfaces. |
|
| 1 | Pressure Regulator Valve Train |
| 2 | Converter Feed Limit Valve Train |
| 3 | Pressure Relief Ball Valve and Spring |
| 4 | TCC Control Valve and Spring |
| 5 | 1-2-3-4 and 3-5 Reverse Clutch Fluid Seal Rings (Qty: 3)
NOTE:
Do not use old seal rings. Install NEW seal rings. Reusing old seal rings may cause internal transmission leaks and transmission damage.
|
| 6 | A/Trans Fluid Pump Locator Pin |