LEMON Manuals: Even more car manuals for everyone
Home >> Chevrolet >> 2012 >> Tahoe PPV >> Repair and Diagnosis >> External Pages >> Different car >> Section 918 (Automatic Transmission - 4L60-E/4L65-E/4L70-E - Removal & Installation, Service, Overhaul, Troubleshooting & Diagnosis) >> On-Vehicle Repair Instructions >> Pressure Regulator Replacement >> Removal Procedure

Removal Procedure

WARNING: This page is about a different car, the 2007 GMC Sierra and 2007 Chevrolet Silverado. However, it is still accessible from the selected car via links, so may be relevant.
    Fig 1: Locating Reverse Boost Valve
    GM687542Courtesy of GENERAL MOTORS CORP.
  1. Remove the transmission filter. Refer to Automatic Transmission Fluid and Filter Replacement .
  2. Compress the reverse boost valve sleeve into the bore of the oil pump to release tension on the reverse boost valve retaining ring.
  3. Remove the reverse boost valve retaining ring, then slowly release tension on the reverse boost valve sleeve.
    4. Fig 2: View Of Reverse Boost Valve, Pressure Regulator Valve & Components
    GM298157Courtesy of GENERAL MOTORS CORP.
  4. Remove the reverse boost valve sleeve (5) and the reverse boost valve (4).
  5. Remove the pressure regulator isolator spring (3) and the pressure regulator valve spring (2).
  6. Remove the pressure regulator valve (1).
scientia non olet · About LEMON Manuals