LEMON Manuals: Even more car manuals for everyone
Home >> Chevrolet >> 2012 >> Tahoe PPV >> Repair and Diagnosis >> External Pages >> Different car >> Section 918 (Automatic Transmission - 4L60-E/4L65-E/4L70-E - Removal & Installation, Service, Overhaul, Troubleshooting & Diagnosis) >> Off-Vehicle Repair Instructions >> Input Speed Sensor Removal

Input Speed Sensor Removal

WARNING: This page is about a different car, the 2007 GMC Sierra and 2007 Chevrolet Silverado. However, it is still accessible from the selected car via links, so may be relevant.
    Fig 1: Identifying Speed Sensor (ISS) Retaining Bolt
    GM1552933Courtesy of GENERAL MOTORS CORP.
  1. Remove the input speed sensor (ISS) retaining bolt (247).
  2. Use a small tipped screwdriver to carefully pry the ISS wiring harness retaining brackets from the pump housing. Being careful not to damage retainer clips.
  3. Remove the ISS assembly (250).
scientia non olet · About LEMON Manuals