LEMON Manuals: Even more car manuals for everyone
Home >> Chevrolet >> 2012 >> Tahoe PPV >> Repair and Diagnosis >> External Pages >> Different car >> Section 1677 (Engine Mechanical - 6.6L (LMM) - Repair Instructions - Off Vehicle (2 Of 3)) >> Fuel Injection Pump Installation

Fuel Injection Pump Installation

WARNING: This page is about a different car, the 2010 GMC Sierra, 2010 GMC Cab & Chassis Sierra, 2010 Chevrolet Silverado, and 2010 Chevrolet Cab & Chassis Silverado. However, it is still accessible from the selected car via links, so may be relevant.
    Fig 1: View Of Fuel Injection Pump
    GM1336114Courtesy of GENERAL MOTORS CORP.
  1. Lubricate the O-ring on the fuel injection pump adapter with engine oil.
    2. Fig 2: Unloading Spring Tension From Two Piece Cam Gear
    GM1650676Courtesy of GENERAL MOTORS CORP.
  2. Use a suitable tool to unload the spring tension from the two piece cam gear. Apply pressure towards the right side of the engine while installing the fuel injection pump.
  3. Install the fuel injection pump and adapter assembly.
    4. CAUTION: Refer to Fastener Caution .
  4. Install the fuel injection pump bolts and tighten to 25 N.m (18 lb ft).
scientia non olet · About LEMON Manuals