LEMON Manuals: Even more car manuals for everyone
Home >> Chevrolet >> 2012 >> Tahoe PPV >> Repair and Diagnosis >> External Pages >> Different car >> Section 1327 (Antilock Brake System - Non-Hybrid Less Than 3900 Kg (8600 Lb) GVW) >> Repair Instructions >> Rear Wheel Speed Sensor Ring Replacement >> Removal Procedure

Removal Procedure

WARNING: This page is about a different car, the 2009 GMC Sierra and 2009 Chevrolet Silverado. However, it is still accessible from the selected car via links, so may be relevant.
  1. Raise the vehicle. Refer to Lifting and Jacking the Vehicle .
  2. Remove the tire and wheel assembly. Refer to Tire and Wheel Removal and Installation .
  3. Remove the rear wheel speed sensor. Refer to Rear Wheel Speed Sensor Replacement .
  4. Remove the rear axle housing cover. Refer to Rear Axle Housing Cover and Gasket Replacement (8.6, 9.5 Inch Axles) or Rear Axle Housing Cover and Gasket Replacement (10.5/11.5 Inch Axle) .
  5. Remove the axle shaft. Refer to Rear Axle Shaft Replacement .
    6. Fig 1: View Of Wheel Speed Sensor Ring, Axle Housing & Removal Tool
    GM889095Courtesy of GENERAL MOTORS CORP.
  6. Remove the axle shaft seal, the bearing and the wheel speed sensor ring from the axle housing using the J-2619-01:  Slide Hammer (1) and the J-45857:  Tone Wheel and/or Bearing Remover (2).
scientia non olet · About LEMON Manuals