Knee Bolster Replacement (With RPO SLT)

WARNING: This page is about a different car, the 2009 GMC Sierra, 2009 GMC Cab & Chassis Sierra, 2009 Chevrolet Silverado, and 2009 Chevrolet Cab & Chassis Silverado. However, it is still accessible from the selected car via links, so may be relevant.

Fig 1: View Of Knee Bolster Assembly & Components

Courtesy of GENERAL MOTORS CORP.

Callout	Component Name
Preliminary Procedures Remove the left instrument panel outer trim cover. Refer to Instrument Panel Outer Trim Cover Replacement (with RPO SLT) or Instrument Panel Outer Trim Cover Replacement (without RPO SLT) . Remove the park brake release handle. Refer to Parking Brake Release Handle Assembly Replacement .
1	Knee Bolster Assembly Screws (Qty: 2) CAUTION: Refer to Fastener Caution . Tighten: 2 N.m (18 lb in)
2	Knee Bolster Assembly Procedure Disconnect the electrical connections. If applicable When replacing the knee bolster assembly, transfer all necessary components.
3	Retainer Clips (Qty: 4)