LEMON Manuals: Even more car manuals for everyone
Home >> Chevrolet >> 2012 >> Tahoe PPV >> Repair and Diagnosis >> External Pages >> Different car >> Section 1233 (Automatic Transmission - 6L50/6L80/6L90 - Removal & Installation, Service, Overhaul, Troubleshooting & Diagnosis) >> Repair Instructions - On Vehicle >> Automatic Transmission Range Selector Lever Replacement

Automatic Transmission Range Selector Lever Replacement

WARNING: This page does not describe the selected car, but rather 7 other vehicles, including the 2008 GMC Yukon XL, 2008 GMC Yukon, 2008 Chevrolet Tahoe, 2008 Chevrolet Suburban, and 2008 Cadillac Escalade EXT. However, it is still accessible from the selected car via links, so may be relevant.
Fig 1: View Of Transmission Range Selector Cable Lever & Nut
GM1707194Courtesy of GENERAL MOTORS CORP.
Callout Component Name

Preliminary Procedures

  1. Apply the park brake.
  2. Shift the transmission into neutral.
  3. Raise the vehicle. Refer to Lifting and Jacking the Vehicle .
  4. Disconnect the transmission range selector cable from the range selector cable lever ball stud.
1 Transmission Range Selector Cable Lever Nut
NOTE: Refer to Fastener Notice .

Tighten:  25 N.m (18 lb ft)

2 Transmission Range Selector Cable Lever