Sunroof Motor/Actuator Replacement (Crew Cab)

WARNING: This page is about a different car, the 2010 GMC Sierra, 2010 GMC Cab & Chassis Sierra, 2010 Chevrolet Silverado, and 2010 Chevrolet Cab & Chassis Silverado. However, it is still accessible from the selected car via links, so may be relevant.

Fig 1: Sunroof Motor/Actuator (Crew Cab)

Courtesy of GENERAL MOTORS CORP.

Callout	Component Name
Preliminary Procedure: It is only necessary to lower the headliner. Only do those step in headliner replacement that will lower the headliner enough to gain access to the part. Refer to Headlining Trim Panel Replacement (Crew Cab) or Headlining Trim Panel Replacement (Extended Cab) or Headlining Trim Panel Replacement (Regular Cab) .
1	Headliner Trim Panel Console Bracket Bolt (Qty: 2) CAUTION: Refer to Fastener Caution . Tighten: 10 N.m (89 lb in)
2	Headliner Trim Panel Console Bracket
3	Sunroof Motor/Actuator Bolt (Qty: 3) Tighten: 4 N.m (35 lb in)
4	Sunroof Motor/Actuator Procedure: Ensure that the motor/actuator is initialize/tech. Refer to Sunroof Motor/Actuator Initialization/Teach Process (Crew Cab Existing Motor) or Sunroof Motor/Actuator Initialization/Teach Process (Extended Cab New Motor) or Sunroof Motor/Actuator Initialization/Teach Process (Extended Cab Existing Motor) or Sunroof Motor/Actuator Initialization/Teach Process (Crew Cab New Motor) .