LEMON Manuals: Even more car manuals for everyone
Home >> Chevrolet >> 2012 >> Tahoe Base, RWD >> Repair and Diagnosis >> External Pages >> Different car >> Section 1543 (Instrument Panel Trim And Console Trim) >> Repair Instructions >> Knee Bolster Replacement (With SLT)

Knee Bolster Replacement (With SLT)

WARNING: This page is about a different car, the 2010 GMC Sierra, 2010 GMC Cab & Chassis Sierra, 2010 Chevrolet Silverado, and 2010 Chevrolet Cab & Chassis Silverado. However, it is still accessible from the selected car via links, so may be relevant.
Fig 1: Knee Bolster (With SLT)
GM1682666Courtesy of GENERAL MOTORS CORP.
Callout Component Name
Preliminary Procedures: 
Remove the left instrument panel outer trim cover. Refer to Instrument Panel Outer Trim Cover Replacement (with RPO SLT)  or Instrument Panel Outer Trim Cover Replacement (without RPO SLT) .
1 Knee Bolster Assembly Screws (Qty: 2)
CAUTION: Refer to Fastener Caution .

Tighten:  2 N.m (18 lb in)
2 Knee Bolster Assembly

Procedure

  1. Disconnect the electrical connections. If applicable
  2. When replacing the knee bolster assembly, transfer all necessary components.
3 Retainer Clips (Qty: 4)
scientia non olet · About LEMON Manuals