Transmission Control Replacement

WARNING: This page is about a different car, the 2008 Cadillac CTS. However, it is still accessible from the selected car via links, so may be relevant.

Fig 1: Transmission Control Replacement

Courtesy of GENERAL MOTORS CORP.

Callout	Component Name
Preliminary Procedures Raise and support the vehicle. Refer to Lifting and Jacking the Vehicle . Disconnect the automatic transmission shift control linkage from the automatic transmission shift control assembly. Refer to Shift Control Linkage Replacement (All Wheel Drive) or Shift Control Linkage Replacement (Rear Wheel Drive) . Lower the vehicle. Remove the automatic transmission control boot assembly. Refer to Transmission Control Lever Boot Replacement . Remove the front floor console assembly. Refer to Front Floor Console Replacement .
1	Shift Control Nut (Qty: 4) NOTE: Refer to Fastener Notice . Tighten: 9 N.m (80 lb in)
2	Automatic Transmission Shift Control Assembly Procedure Disconnect the electrical connector from the shift control. Adjust the automatic transmission shift control linkage after installing the automatic transmission shift control assembly. Refer to Shift Control Linkage Adjustment (All Wheel Drive) or Shift Control Linkage Adjustment (Rear Wheel Drive) .

Callout

Component Name

Preliminary Procedures

Raise and support the vehicle. Refer to Lifting and Jacking the Vehicle .
Disconnect the automatic transmission shift control linkage from the automatic transmission shift control assembly. Refer to Shift Control Linkage Replacement (All Wheel Drive) or Shift Control Linkage Replacement (Rear Wheel Drive) .
Lower the vehicle.
Remove the automatic transmission control boot assembly. Refer to Transmission Control Lever Boot Replacement .
Remove the front floor console assembly. Refer to Front Floor Console Replacement .

Shift Control Nut (Qty: 4)

NOTE: Refer to Fastener Notice .

Tighten: 9 N.m (80 lb in)

Automatic Transmission Shift Control Assembly

Procedure

Disconnect the electrical connector from the shift control.
Adjust the automatic transmission shift control linkage after installing the automatic transmission shift control assembly. Refer to Shift Control Linkage Adjustment (All Wheel Drive) or Shift Control Linkage Adjustment (Rear Wheel Drive) .