Input and Output Speed Sensor Assembly Installation

WARNING: This page is about a different car, the 2008 Cadillac CTS. However, it is still accessible from the selected car via links, so may be relevant.

Fig 1: Input and Output Speed Sensor Assembly Component View

Courtesy of GENERAL MOTORS CORP.

Callout	Component Name
1	A/Trans Input and Output Speed Sensor Wiring Harness Clip (Qty: 2) Tip: Inspect the 2 wiring harness clips for damage. Replace if damaged.
2	A/Trans Input and Output Speed Sensor Assembly
3	Bolt M6 x 20 (Qty: 2) NOTE: Refer to Fastener Notice . Tighten: 12 N.m (106 lb in)