LEMON Manuals: Even more car manuals for everyone
Home >> Chevrolet >> 2012 >> Suburban C2500 >> Repair and Diagnosis >> External Pages >> Different car >> Section 1902 (Engine Mechanical - Hybrid (LZ1) - Repair Instructions - On Vehicle) >> Repair Instructions - On Vehicle >> Valve Stem Oil Seal and Valve Spring Replacement >> Removal Procedure

Removal Procedure

WARNING: This page is about a different car, the 2012 GMC Yukon, 2012 Chevrolet Tahoe, and 2012 Cadillac Escalade. However, it is still accessible from the selected car via links, so may be relevant.
    Fig 1: View Of Spark Plug Wire & Boot
    GM343699Courtesy of GENERAL MOTORS COMPANY
  1. Remove the rocker arm. Refer to Valve Rocker Arm and Push Rod Replacement .
  2. Disconnect the spark plug wire at the spark plug.
    • Twist each plug wire boot 1/2 turn.
    • Pull only on the boot in order to remove the wire from the spark plug.
    3. Fig 2: View Of Spark Plug And Sparkplug Seat
    GM14824Courtesy of GENERAL MOTORS COMPANY
    NOTE:

    Remove the spark plugs from the cylinder head with the engine at room temperature.

  3. Loosen the spark plug 1 or 2 turns.
  4. Brush or air blast away any dirt or debris from around the spark plug.
  5. Remove the spark plug.
    6. Fig 3: Applying Compressed Air To J 22794
    GM310140Courtesy of GENERAL MOTORS COMPANY
  6. Install the J 22794  spark plug port adapter into the spark plug hole.
  7. Attach an air hose to the J 22794  spark plug port adapter.
  8. Apply compressed air to the J 22794  spark plug port adapter in order to hold the valves in place.
    9. Fig 4: Compressing Valve Spring
    GM218211Courtesy of GENERAL MOTORS COMPANY
  9. Use the J 38606  valve spring compressor in order to compress the valve spring.
    10. Fig 5: Valve Stem Keys, Valve Spring Cap & Valve Spring
    GM1559870Courtesy of GENERAL MOTORS COMPANY
  10. Remove the valve stem keys (225).
  11. Carefully release the valve spring tension.
  12. Remove the J 38606  valve spring compressor.
  13. Remove the valve spring cap (224).
  14. Remove the valve spring (223).
  15. Remove the valve stem oil seal (222).
  16. Remove the valve (228).
scientia non olet · About LEMON Manuals