LEMON Manuals: Even more car manuals for everyone
Home >> Chevrolet >> 2012 >> Suburban C2500 >> Repair and Diagnosis >> External Pages >> Different car >> Section 1901 (Transfer Case - BW 4485 (Nr3)) >> Repair Instructions - On Vehicle >> Rear Output Shaft Seal Replacement >> Installation Procedure

Installation Procedure

WARNING: This page is about a different car, the 2012 GMC Yukon XL, 2012 GMC Yukon, 2012 Cadillac Escalade EXT, 2012 Cadillac Escalade ESV, and 2012 Cadillac Escalade. However, it is still accessible from the selected car via links, so may be relevant.
    Fig 1: View Of Front Output Shaft Seal Installation Special Tool
    GM1728916Courtesy of GENERAL MOTORS COMPANY
  1. Using the J 45756  installer, install a NEW front output shaft seal.
  2. Install the rear propeller shaft. Refer to Rear Propeller Shaft Replacement .
  3. Check the fluid level. Add fluid, if necessary.
  4. Install the transfer case shield, if equipped. Refer to Transfer Case Shield Replacement .
  5. Lower the vehicle.
scientia non olet · About LEMON Manuals