LEMON Manuals: Even more car manuals for everyone
Home >> Chevrolet >> 2012 >> Suburban C2500 >> Repair and Diagnosis >> External Pages >> Different car >> Section 1894 (Engine Controls/Fuel - Hybrid (LZ1) - Repair Instructions) >> Repair Instructions >> Evaporative Emission Canister Purge Solenoid Valve Replacement >> Installation Procedure

Installation Procedure

WARNING: This page is about a different car, the 2012 GMC Yukon, 2012 Chevrolet Tahoe, and 2012 Cadillac Escalade. However, it is still accessible from the selected car via links, so may be relevant.
    Fig 1: View Of EVAP Canister Purge Solenoid
    GM1706144Courtesy of GENERAL MOTORS COMPANY
  1. Install the EVAP canister purge solenoid.
  2. Install the EVAP canister purge solenoid to the fuel rail and engage the retainer.
    3. Fig 2: View Of Engine Wiring Harness Electrical Connectors, EVAP Purge Solenoid & MAP Sensor
    GM1960247Courtesy of GENERAL MOTORS COMPANY
  3. Connect the engine wiring harness electrical connector (2) to the EVAP canister purge solenoid (3).
  4. Connect the chassis EVAP line quick connect fitting to the EVAP canister purge solenoid. Refer to Plastic Collar Quick Connect Fitting Service .
    5. Fig 3: View of EVAP Line & Canister Purge Solenoid
    GM1706143Courtesy of GENERAL MOTORS COMPANY
  5. Connect the EVAP line quick connect fitting to the EVAP canister purge solenoid. Refer to Plastic Collar Quick Connect Fitting Service .
  6. Install the intake manifold sight shield. Refer to Upper Intake Manifold Sight Shield Replacement .
scientia non olet · About LEMON Manuals