Conditions for Running the DTC
WARNING: This page is about a different car, the 2012 GMC Yukon, 2012 Chevrolet Tahoe, and 2012 Cadillac Escalade. However, it is still accessible from the selected car via links, so may be relevant.
P0AEE, P0AF3, P0BD2, P0BD7, P0BDC, and P0BE1
- Ignition ON after the ignition has been OFF for 6 hours.
- Temperature average of the inverter phase temperature sensors is greater than 12°C (10°F).
- Motor temperature sensor is greater than -40°C (-40°F).
- DTCs P0AEF, P0AF0, P0BD3, P0BD4, P0BDD, P0BDE, P0A2C, and P0A2D are not set.
P0AEF, P0AF4, P0BD3, P0BD8, P0BDD, and P0BE2
The ignition is ON.
P0AF0, P0AF5, P0BD4, P0BD9, P0BDE, and P0BE3
- The ignition is ON.
- Motor temperature is greater than -40°C (-40°F). If motor temperature is less than -40°C (-40°F) at Ignition ON, the drive motor must operate at greater than 20 N.m (14.75 lb ft) for a cumulative time of 1.5 minutes before the DTC will run.