Circuit/System Testing
WARNING: This page is about a different variant/trim than selected.
- Ignition OFF, disconnect the harness connector at the EBCM.
- Test for less than 1 Ω between the ground circuits listed below and ground.
- Terminal 1
- Terminal 25
- If greater than the specified range, test the ground circuits for an open/high resistance.
- Ignition ON, verify that a test lamp illuminates between the B+ circuits listed below and ground.
- Terminal 13
- Terminal 38
- If the test lamp does not illuminate, test the B+ circuits for a short to ground or an open/high resistance.
- If all circuits test normal, replace the EBCM.