Holding Fixture Installation and Torque Dampener Removal

WARNING: This page is about a different car, the 2012 GMC Yukon, 2012 Chevrolet Tahoe, and 2012 Cadillac Escalade. However, it is still accessible from the selected car via links, so may be relevant.

Fig 1: Holding Fixture Removal/Installation and Torque Dampener

Courtesy of GENERAL MOTORS COMPANY

Callout	Component Name
1	A/Trans Torque Dampener Assembly Special Tools J 21366 Converter Holding Strap
2	A/Trans Case Assembly Procedure Rotate the transmission so that the dampener housing is up and secure with locking pin. Allow any remaining transmission fluid to drain from the case extension. Special Tools DT-48307 Holding Fixture J 3289-20 Holding Fixture Base Assembly

Callout

Component Name

A/Trans Torque Dampener Assembly
Special Tools
J 21366 Converter Holding Strap

A/Trans Case Assembly

Procedure

Rotate the transmission so that the dampener housing is up and secure with locking pin.
Allow any remaining transmission fluid to drain from the case extension.

Special Tools

DT-48307 Holding Fixture
J 3289-20 Holding Fixture Base Assembly