LEMON Manuals: Even more car manuals for everyone
Home >> Chevrolet >> 2012 >> Suburban C1500 >> Repair and Diagnosis >> External Pages >> Different car >> Section 1896 (Automatic Transmission - 2ML70 - Diagnostic Information And Procedures) >> Diagnostic Information and Procedures >> Whine/Growl Noise That Changes with Vehicle Speed

Whine/Growl Noise That Changes with Vehicle Speed

WARNING: This page is about a different car, the 2012 GMC Yukon, 2012 Chevrolet Tahoe, and 2012 Cadillac Escalade. However, it is still accessible from the selected car via links, so may be relevant.
Whine/Growl Noise That Changes with Vehicle Speed

Checks Causes
Input Shaft Thrust Bearing Assembly (60) Inspect the bearing for wear or damage.
Sun Gear Carrier Thrust Bearing Assembl (66)
  • Inspect the carrier assembly for damaged pinion gears, thrust washers, pins, and rollers.
  • Inspect for a damaged center support roller bearing assembly.
  • Inspect for damaged thrust bearings.
  • Inspect for damaged sun gears.
  • Inspect the carrier assembly for damaged output carrier rear sun gear thrust bearing (captured).
  • Inspect for damaged or stripped splines on the output carrier assembly.
Internal Gear Thrust Bearing Assembly (68, 76) Inspect the bearing for wear or damage.
2WD Output Bushing (25)
  • Inspect for damaged internal gears.
  • Inspect the output carrier bushing for damage or wear.
2-3-4 Clutch Hub Thrust Bearing Assembly (78) Inspect the bearing for wear or damage.
2-3-4 Clutch Housing Thrust Bearing Assembly (81) Inspect the washer for wear or damage.
Input Shaft Bushing (203) Inspect the bushing for wear or damage.
1-3 Clutch Housing Bushing (420) Inspect the bushing for wear or damage.
Internal Gear Thrust Washer - 3rd Position - Steel (433) Inspect the carrier assembly for damaged pinion gears, thrust washers, pins, and rollers.
Internal Gear Thrust Bearing Assembly (435) Inspect the bearing for wear or damage.
Output Shaft Thrust Bearing Assembly (437) Inspect the output carrier inner sun gear shaft bushings for damage or wear.
2-3-4 Clutch Housing Thrust Bearing Assembly (441)
  • Inspect for damaged or restricted fluid filter assembly.
  • Inspect for damaged fluid filter seal assembly or improper sealing interface (leaks, fluid aeration).
Internal Gear Thrust Washer - 3rd Position - Plastic (459) Inspect the bearing for wear or damage.