Instrument Cluster Scan Tool Information
Instrument Cluster Scan Tool Data Parameters
| Parameter | Expected Value | Definition |
|---|---|---|
| Operating Conditions: Ignition ON | ||
| Ambient Air Temperature | Varies | The scan tool displays the outside temperature in °C (°F). |
| Battery Voltage | Varies | The scan tool displays the battery voltage in V. |
| Boost Pressure Sensor | Varies | The scan tool displays the engine boost pressure in %. |
| Coolant Level Switch | On/Off | The scan tool displays Off or On depending on the coolant level. |
| Driver Information Center Switch | Varies | The scan tool displays V depending on the driver information center switch position. |
| Driver Information Center Switch | Inactive | The scan tool displays Inactive, Up, Down, Menu or Clear depending on the driver information center switch position. |
| Engine Coolant Temperature | Varies | The scan tool displays the engine coolant temperature in °C (°F). |
| Engine Oil Pressure | Varies | The scan tool displays the engine oil pressure in kPa (PSI). |
| Engine Speed | Varies | The scan tool displays the engine speed in RPM. |
| Fuel Level Sensor | Varies | The scan tool displays the fuel level in %. |
| Key in Ignition Status | Active/Inactive | The scan tool displays Active or Inactive. This is the state of the key in ignition switch. |
| Odometer Lock Status | Active/Inactive | The scan tool displays Active or Inactive depending on the state of the odometer. |
| Reset Switch | Active/Inactive | The scan tool displays Active or Inactive depending on the reset switch position. |
| Vehicle Speed | Varies | The scan tool displays the vehicle speed in km/h (MPH). |
| Washer Fluid Heater | On/Off | The scan tool displays On or Off. On is displayed, when the washer fluid heater is active. |
| Washer Fluid Level Switch | On/Off | The scan tool displays On or Off depending on the washer fluid level. |
Instrument Cluster Scan Tool Output Controls
| Scan Tool Output Control | Description |
|---|---|
| All Indicators | This function is used to command all the indicators ON or OFF. |
| Driver Information Center Dimming | This function is used to command the dimming of the driver information display to Increase or Decrease by 10%. |
| Driver Information Center Options | This function is used to command the driver information center buttons using the scan tool. |
| Driver Information Center Segments | This function is used to command the driver information center segments ON and OFF. |
| Instrument Cluster Gauge Sweep | This function is used to command the gauges to sweep briefly from minimum to maximum and vice versa. |
| Instrument Cluster Dimming | This function is used to command the dimming of the instrument cluster to Increase or Decrease by 10%. |