Component Testing
Static Test
- Ignition OFF, disconnect the harness connector at the G12 Fuel Pump.
- Test for 40-250 Ω between the signal terminal 4 and the low reference terminal 3.
- If not within the specified range, replace the G12 Fuel Pump.
Dynamic Test
- Ignition OFF, disconnect the harness connector at the G12 Fuel Pump.
- Remove the fuel level sensor from the fuel tank.
- Sweep the sensor through the entire range while monitoring the resistance between the signal terminal 4 and the low reference terminal 3. The resistance should vary between less than 45 Ω and greater than 250 Ω without any spikes or dropouts.
- If not within the specified range or is erratic, replace the G12 Fuel Pump.