Coolant Heater Cord Replacement

Coolant Heater Cord Replacement (V8)

Removal Procedure





1. Raise and suitably support the vehicle. Refer to Lifting and Jacking the Vehicle Service and Repair.

2. Disconnect the coolant heater electrical connector (1).





3. Remove the coolant heater cord retainers (1).

Note:
Note location of cord prior to removal.

4. Remove the coolant heater cord.

Installation Procedure

Caution:
The heater cord must not touch the engine, hot pipes, manifold, or any moving parts. Route the cord to the left front of the engine compartment securing with tie straps as necessary to prevent damage.





1. Install the coolant heater cord.

Caution:
Refer to Fastener Caution Fastener Caution.

2. Install the coolant heater cord retainers (1).





3. Connect the coolant heater electrical connector (1).

4. Lower the vehicle.