Windshield Moulding / Trim: Service and Repair

Windshield Frame Filler Panel Applique Replacement

Removal Procedure





1. Remove the screws (2) retaining the applique (3) to the filler panel.

2. Pull the applique (3) away from the filler panel in order to release the retainer (1).

3. Remove the applique (3) from the vehicle.

Installation Procedure





1. Install the applique (3) to the vehicle.

2. Install the retainer (1) into the slot in the filler panel. Press the retainer into place.

Caution:
Refer to Fastener Caution Fastener Caution.

3. Install the screws (2) in order to retain the applique (3) to the upper fender filler panel and tighten to 2 Nm (18 lb in).