Locking Differential Cam Unit Disassemble (9.5 Inch Axle)

Locking Differential Cam Unit Disassemble (9.5 Inch Axle)

Special Tools

* J 22912-01 - Split Plate Bearing Puller

* J 45232 - Adjuster Bearing Replacer (Left Side)

1. Measure and record the overall length of the locking differential side gear assembly from the front of the locking differential side locking differential side gear to thrust washer.

2. Remove the guide clips.





3. Using the J 22912-01 - puller (2), J 45232 - replacer (1) and a hydraulic press, remove the locking differential side gear thrust sleeve.





4. Remove the locking differential clutch disc thrust washer (7).

5. Remove the locking differential side gear thrust sleeve (6).

6. Remove the locking differential clutch disc set (1).

Note:
The locking differential clutch disc guide is NOT serviced separately. It is serviced with the locking differential clutch disc assembly.

7. Remove the locking differential clutch disc guide.

8. Disassemble the locking differential clutch disc assembly (1).