LEMON Manuals: Even more car manuals for everyone
Home >> Chevrolet >> 2012 >> Cruze LTZ >> Repair and Diagnosis >> External Pages >> Different car >> Section 218 (Engine Mechanical - 1.8L (2H0 Or LUW) - Repair Instructions - Off Vehicle (1 Of 2)) >> Intake Manifold Disassemble

Intake Manifold Disassemble

WARNING: This page is about a different car, the 2011 Chevrolet Cruze. However, it is still accessible from the selected car via links, so may be relevant.
    Fig 1: Intake Manifold, Manifold Absolute Pressure Sensor And Bolt
    GM2189143Courtesy of GENERAL MOTORS CORP.
  1. Remove the intake manifold absolute pressure sensor bolt (1).
  2. Remove the manifold absolute pressure sensor (2) from the intake manifold (3).
    3. Fig 2: Intake Manifold And Mount
    GM2189144Courtesy of GENERAL MOTORS CORP.
  3. Remove the intake manifold mount (2) from the intake manifold (1).
    4. Fig 3: Intake Manifold, Intake Manifold Seal And Throttle Body Seal
    GM2189145Courtesy of GENERAL MOTORS CORP.
  4. Remove the throttle body seal (1).
  5. Remove the intake manifold seal (3) from the intake manifold (2).
    6. Fig 4: Intake Manifold, Evaporative Emission Canister Purge Solenoid Valve Bracket And Bolts
    GM2373076Courtesy of GENERAL MOTORS CORP.
  6. Remove the 2 evaporative emission canister purge solenoid valve bracket bolts (2).
  7. Remove the evaporative emission canister purge solenoid valve bracket (1) from the intake manifold (3).
    8. Fig 5: Intake Manifold, Multiport Fuel Injection Fuel Rail, Fuel Injectors, Seals And Bolts
    GM2373077Courtesy of GENERAL MOTORS CORP.
  8. Remove the 2 multiport fuel injection fuel rail bolts (1).
  9. Remove the multiport fuel injection fuel rail (2) and the fuel injectors (3) from the intake manifold (5).
  10. Remove the 4 multiport fuel injector seals (4).
scientia non olet · About LEMON Manuals