Rear Side Door Trim Replacement

Fig 1: Rear Side Door Trim

Courtesy of GENERAL MOTORS COMPANY

Callout	Component Name
1	Rear Side Door Inside Handle Bolt Finish Cap Procedure Pull handle back to remove cap. Use suitable tool to unsnap.
2	Rear Side Door Inside Handle Screw CAUTION: Refer to Fastener Caution . Tighten 2.5 N.m (22 lb in)
3	Rear Side Door Pull Handle Screw Tighten 2.5 N.m (22 lb in)
4	Rear Side Door Trim Clip (Qty: 5) NOTE: Use a NEW retainer before installing the rear side door trim. Special Tools BO-38778 Door Trim Panel Clip Remover For equivalent regional tools, refer to Special Tools .
5	Rear Side Door Trim Assembly Procedure Pull upwards on the door lock retainer cable to disengage. Disconnect the electrical connectors. TIP: Only use BO-38778 remover to disengage the door trim clips from the door. Do not disengage the clips by pulling from the map pocket area, since this can distort the trim panel.