Special Tools
WARNING: This page is about a different car, the 2011 Chevrolet Cruze. However, it is still accessible from the selected car via links, so may be relevant.
EN-45059: Torque Angle Sensor Kit
For equivalent regional tools, refer to Special Tools .
- Install the camshaft adjuster (3) and the camshaft adjuster bolts (2) and tighten the bolts in three passes:
Hold at the appropriate camshaft hexagon.
- First pass tighten to 65 N.m (48 lb ft)
- Second pass to 120° , using the EN-45059: sensor kit
- Third pass to 15° , using the EN-45059: sensor kit
- Install the 2 camshaft adjuster closure plugs (1) and tighten to 30 N.m (22 lb ft).
CAUTION:
Refer to Fastener Caution
.
NOTE:
A second technician is required.