LEMON Manuals: Even more car manuals for everyone
Home >> Chevrolet >> 2012 >> Cruze Eco, Automatic Trans >> Repair and Diagnosis >> External Pages >> Different variant/trim >> Section 6 (Manual Transmission Clutch System) >> Repair Instructions >> Clutch Master Cylinder Replacement >> Installation Procedure

Installation Procedure

WARNING: This page is about a different variant/trim than selected.
    Fig 1: Clutch Master Cylinder
    GM2191663Courtesy of GENERAL MOTORS COMPANY
  1. Install the clutch master cylinder (1).
    2. Fig 2: Clutch Master Cylinder Nuts
    GM2191662Courtesy of GENERAL MOTORS COMPANY
    CAUTION:

    Refer to Fastener Caution .

  2. Install the 2 clutch master cylinder nuts (1) and tighten to 18 N.m (13 lb ft).
    3. Fig 3: Clutch Pedal Push Rod Retainer And Latches
    GM2191661Courtesy of GENERAL MOTORS COMPANY
    NOTE:

    The retaining clip (arrows) has to engage audibly.

  3. Connect the push rod retainer (1) to the clutch pedal.
    4. Fig 4: Clutch Actuator Cylinder Front Pipe And Retaining Clip
    GM2191675Courtesy of GENERAL MOTORS COMPANY
  4. Connect the clutch actuator cylinder front pipe (1) to the clutch master cylinder.
  5. Close the retaining clip (arrow).
    6. Fig 5: Clutch Actuator Cylinder Front Pipe And Retainers
    GM2191660Courtesy of GENERAL MOTORS COMPANY
  6. Clip the clutch actuator cylinder front pipe (1) into the 2 retainers (arrows).
    7. Fig 6: Clutch Master Cylinder Reservoir Hose
    GM2191659Courtesy of GENERAL MOTORS COMPANY
  7. Install the clutch master cylinder reservoir hose (1) to the clutch master cylinder.
    8. Fig 7: Radiator Surge Tank And Radiator Surge Tank Clip
    GM2027873Courtesy of GENERAL MOTORS COMPANY
  8. Install the radiator surge tank (1).
  9. Install the radiator surge tank clip (2).
  10. Bleed the hydraulic clutch system. Refer to Hydraulic Clutch System Bleeding .
  11. Install the battery tray. Refer to Battery Tray Replacement .
scientia non olet · About LEMON Manuals