Removal Procedure
WARNING: This page is about a different variant/trim than selected.
- Remove the transmission. Refer to Transmission Replacement .
- Remove the clutch actuator cylinder pipe elbow (2) and the clutch actuator cylinder pipe sleeve (1). The clutch actuator pipe seal must not stick in the elbow pipe.
- Remove the 3 clutch actuator cylinder bolts (3).
- Remove the clutch actuator cylinder (2).
- Remove and DISCARD the clutch actuator cylinder seal (4).
- Remove and DISCARD the clutch actuator cylinder pipe seal (1)
WARNING:
When adding fluid to the brake fluid reservoir or to the clutch fluid reservoir, use only DOT-4+ brake fluid from a clean, sealed container. This polyglycol brake fluid is hygroscopic and absorbs moisture. Do not use fluid from an open container that may be contaminated with water. Brake fluid must not be contaminated with mineral oil. Improper or contaminated fluid could result in system failure, loss of vehicle control, and possible injury. Complaints because of, or defects caused by contaminated brake fluid will not be accepted by GM warranty.