Installation Procedure
WARNING: This page is about a different variant/trim than selected.
- Clean the 3 clutch actuator cylinder threads in clutch housing.
- Install the NEW clutch actuator cylinder pipe seal (1).
- Install the NEW clutch actuator cylinder seal (4).
- Install the clutch actuator cylinder (2).
- Install 3 NEW clutch actuator cylinder bolts (3) and handtighten them equally.
- Tighten the 3 clutch actuator cylinder bolts to 6 N.m (53 lb in).
- Install clutch actuator cylinder pipe sleeve (1) and clutch actuator cylinder pipe elbow (2).
- Install transmission. Refer to Transmission Replacement .
WARNING:
Use the correct fastener in the correct location. Replacement fasteners must be the correct part number for that application. Do not use paints, lubricants, or corrosion inhibitors on fasteners, or fastener joint surfaces, unless specified. These coatings affect fastener torque and joint clamping force and may damage the fastener. Use the correct tightening sequence and specifications when installing fasteners in order to avoid damage to parts and systems. When using fasteners that are threaded directly into plastic, use extreme care not to strip the mating plastic part(s). Use hand tools only, and do not use any kind of impact or power tools. Fastener should be hand tightened, fully seated, and not stripped.
CAUTION:
Refer to Fastener Caution .