LEMON Manuals: Even more car manuals for everyone
Home >> Chevrolet >> 2012 >> Cruze Eco, Automatic Trans >> Repair and Diagnosis >> External Pages >> Different variant/trim >> Section 6 (Manual Transmission Clutch System) >> Repair Instructions >> Clutch Actuator Cylinder Front Pipe Replacement >> Removal Procedure

Removal Procedure

WARNING: This page is about a different variant/trim than selected.
  1. Remove battery tray. Refer to Battery Tray Replacement .
    2. Fig 1: Radiator Surge Tank And Radiator Surge Tank Clip
    GM2027873Courtesy of GENERAL MOTORS COMPANY
  2. Remove radiator surge tank clip (2).
  3. Remove radiator surge tank (1) and lay aside.
  4. Place basin underneath.
    5. Fig 2: Clutch Actuator Cylinder Front Pipe And Retainers
    GM2192334Courtesy of GENERAL MOTORS COMPANY
  5. Clip clutch actuator cylinder front pipe (2) out of 2 retainers.
  6. Open retaining clip (1).
  7. Disconnect clutch actuator cylinder front pipe from clutch actuator cylinder pipe elbow.
    8. Fig 3: Brake Pressure Modulator Valve Bracket Bolts
    GM2191673Courtesy of GENERAL MOTORS COMPANY
  8. Remove 2 brake pressure modulator valve bracket bolts (1).
    9. Fig 4: Clutch Actuator Cylinder Front Pipe And Retaining Clip
    GM2191675Courtesy of GENERAL MOTORS COMPANY
  9. Open retaining clip (arrow).
  10. Disconnect clutch actuator cylinder front pipe (1) from clutch master cylinder.
    11. NOTE:

    For removal of clutch actuator cylinder front pipe lift brake pressure modulator valve bracket carefully.

  11. Remove clutch actuator cylinder front pipe.
scientia non olet · About LEMON Manuals