LEMON Manuals: Even more car manuals for everyone
Home >> Chevrolet >> 2012 >> Cruze Eco, Automatic Trans >> Repair and Diagnosis >> External Pages >> Different variant/trim >> Section 6 (Manual Transmission Clutch System) >> Repair Instructions >> Clutch Actuator Cylinder Front Pipe Replacement >> Installation Procedure

Installation Procedure

WARNING: This page is about a different variant/trim than selected.
    NOTE:

    For installation of clutch actuator cylinder front pipe lift brake pressure modulator valve bracket carefully.

  1. Install clutch actuator cylinder front pipe.
    2. Fig 1: Clutch Actuator Cylinder Front Pipe And Retaining Clip
    GM2191675Courtesy of GENERAL MOTORS COMPANY
  2. Connect clutch actuator cylinder front pipe (1) to clutch master cylinder.
  3. Close retaining clip (arrow).
    4. Fig 2: Clutch Actuator Cylinder Front Pipe And Retainers
    GM2192334Courtesy of GENERAL MOTORS COMPANY
  4. Connect clutch actuator cylinder front pipe (2) to clutch actuator cylinder pipe elbow.
  5. Close retaining clip (1).
  6. Clip clutch actuator cylinder front pipe into 2 retainers.
    7. Fig 3: Brake Pressure Modulator Valve Bracket Bolts
    GM2191673Courtesy of GENERAL MOTORS COMPANY
    CAUTION:

    Refer to Fastener Caution .

  7. Install 2 brake pressure modulator valve bracket bolts (1) and tighten to 20 N.m (15 lb ft).
    8. Fig 4: Radiator Surge Tank And Radiator Surge Tank Clip
    GM2027873Courtesy of GENERAL MOTORS COMPANY
  8. Install radiator surge tank (1).
  9. Install radiator surge tank clip (2).
  10. Bleed hydraulic clutch system. Refer to Hydraulic Clutch System Bleeding .
  11. Install battery tray. Refer to Battery Tray Replacement .
scientia non olet · About LEMON Manuals