Inspection/Maintenance (I/M) System DTC Table
WARNING: This page is about a different variant/trim than selected.
Inspection/Maintenance (I/M) System DTC Table
| System | DTCs Required to Set System Status to YES |
|---|---|
| If an inspection/maintenance system status indicator did NOT update to YES during the Inspection/Maintenance System Check , review each indicator and reference this table to determine each DTC associated with the inspection/maintenance system status indicator. Each DTC listed below has specific conditions that must be met for the diagnostic to run. Included within the conditions are additional DTCs which, if set, may inhibit the DTCs listed below from running. Reviewing and operating the vehicle within the conditions for running for each DTC listed below will allow the inspection/maintenance system status indicators to transition to YES. | |
| Catalyst Monitor | DTC P0420 (LUW) . |
| Evaporative emission (EVAP) | |
| Oxygen sensor | |
| Oxygen sensor heater | DTC P0030-P0032, P0036-P0038, P0053, P0054, P0135, or P0141 (LUW) |
| Camshaft System | DTC P0011 or P0014 (LUW) |