LEMON Manuals: Even more car manuals for everyone
Home >> Chevrolet >> 2012 >> Cruze Eco, Automatic Trans >> Repair and Diagnosis >> External Pages >> Different variant/trim >> Section 5 (Engine Controls/Fuel - 1.8L - DTC Diagnostics, Troubleshooting & Diagnosis) >> Diagnostic Information and Procedures >> DTC P1516, P2101, P2119, or P2176 (LUW) >> Repair Verification

Repair Verification

WARNING: This page is about a different variant/trim than selected.
  1. Install any components that have been removed or replaced during diagnosis.
  2. Perform any adjustments, programming or setup procedures that are required when a component is removed or replaced.
  3. Clear the DTCs with a scan tool.
  4. Turn OFF the ignition for 60 s.
  5. Perform the Throttle Sweep Test while observing the TAC Motor parameter with a scan tool. The TAC Motor parameter should display Enabled while the Throttle Sweep Test is in progress.
    • If Disabled is displayed, a condition still exists.
  6. If the repair was related to a DTC, duplicate the Conditions for Running the DTC and use the Freeze Frame/Failure Records, if applicable, in order to verify the DTC does not reset. If the DTC resets or another DTC is present, refer to the Diagnostic Trouble Code (DTC) List - Vehicle and perform the appropriate diagnostic procedure.
scientia non olet · About LEMON Manuals