Conditions for Running the DTC

P1516

• The run/crank or powertrain relay voltage is greater than 6.41 V and reduced power is not active.
• The DTC runs continuously when the above conditions are met.

P2101

• DTC P1682 is not set.
• The run/crank or powertrain relay voltage is greater than 6.41 V and reduced power is not active.
• The throttle position sensor (TPS) minimum learn is not active.
• The throttle is being controlled.
• The running or ignition voltage is greater than 11 V.
• The ignition voltage is greater than 5.5 V.

  OR

• The TPS minimum learn and reduced power are active.
• The powertrain relay voltage is greater than 6.41 V.
• The DTC runs continuously when the above conditions are met.

P2119

• DTCs P0122, P0123, P0222, P0223, or P06A3 are not set.
• The run/crank or powertrain relay voltage is greater than 6.41 V and reduced power is not active.
• The powertrain relay voltage is greater than 5.5 V.
• The DTC runs continuously when the above conditions are met.

P2176

• The run/crank or powertrain relay voltage is greater than 6.41 V and reduced power is not active.
• The DTC runs continuously when the above conditions are met for greater than 2 s.