LEMON Manuals: Even more car manuals for everyone
Home >> Chevrolet >> 2012 >> Cruze Eco, Automatic Trans >> Repair and Diagnosis >> External Pages >> Different variant/trim >> Section 5 (Engine Controls/Fuel - 1.8L - DTC Diagnostics, Troubleshooting & Diagnosis) >> Diagnostic Information and Procedures >> DTC P0641 or P06A6 (Fuel Pump Control Module) >> Circuit/System Testing

Circuit/System Testing

WARNING: This page is about a different variant/trim than selected.
  1. Ignition OFF, disconnect harness connector of the B47 fuel pressure sensor.
  2. Ignition OFF, test for less than 1.0 Ω between the low reference circuit terminal 2 and ground.
    • If greater than the specified range, test the low reference circuit for an open/high resistance. If the circuit tests normal, replace the K27 fuel pump control module.
  3. Ignition ON, test for 4.8-5.2 V between the 5 V reference circuit terminal 3 and ground.
    • If less than the specified range, test the 5 V reference circuit for a short to ground or an open/high resistance. If the circuit tests normal, replace the K27 fuel pump control module.
    • If greater than the specified range, test the 5 V reference circuit for a short to voltage. If the circuit tests normal, replace the K27 fuel pump control module.
  4. If all circuits test normal, replace the B47 fuel pressure sensor.
scientia non olet · About LEMON Manuals