Conditions for Running the DTC

WARNING: This page is about a different variant/trim than selected.

DTCs P00C8, P00C9, P010C, P010D, P16A0, P16A1, P16A2, P160E, P160D, P16F3, P0068, P0101, P0102, P0103, P0111, P0112, P0113, P0114 P0116, P0117, P0118, P0122, P0123, P0125, P0128, P0191, P0192, P0193, P0222, P0223, P0443, P0449, P0452, P0453, P0454, P0502, P0503, P0601, P0604, P0606, P0722, P0723, P1104, P1682, P2100, P2101, P2102, P2103, P2135, P2176, P2227, P2228, P2229, P2230 are not set.
The ignition voltage is between 11-32 V.
The barometric pressure (BARO) is greater than 70 kPa.
The fuel level is between 10-90 %.
The EVAP purge flow is greater than 2.80 %
The cold startup engine coolant temperature (ECT) and the startup intake air temperature (IAT) are within 8°C (46°F).
The startup engine coolant temperature (ECT) is less than 35°C (95°F).
The startup intake air temperature (IAT) is between 4-30°C (39-86°F).
DTC P0455 runs once per cold start, for up to 17 min, when the above conditions are met.