Component Testing
WARNING: This page is about a different variant/trim than selected.
Static Test
- Ignition OFF, disconnect the harness connector at the Q12 Evaporative Emission Purge Solenoid Valve.
- Test for 10.0-30.0 Ω between the control circuit terminal 1 and the ignition circuit terminal 2 of the Q12 Evaporative Emission Purge Solenoid Valve.
- If not between 10.0-30.0 Ω
Replace the Q12 Evaporative Emission Purge Solenoid Valve
- If between 10.0-30.0 Ω
- If not between 10.0-30.0 Ω
- All OK.