Circuit/System Verification
WARNING: This page is about a different variant/trim than selected.
- Ignition ON.
- Verify the parameters listed below do not display malfunction when commanding the EVAP purge solenoid valve from 0 to 50 % and back to 0 % with a scan tool.
- EVAP Purge Solenoid Valve Control Circuit Low Voltage Test Status
- EVAP Purge Solenoid Valve Control Circuit Open Test Status
- EVAP Purge Solenoid Valve Control Circuit High Voltage Test Status
- If Malfunction is displayed
Refer to Circuit/System Testing below.
- If Malfunction is not display
- All OK.