Circuit/System Verification
WARNING: This page is about a different variant/trim than selected.
- Engine running, observe the following scan tool control circuit status parameters for the appropriate cylinder ignition coil. Each parameter should not display Malfunction:
- Ignition Coil 1-4 Control Circuit Low Voltage Test Status
- Ignition Coil 1-4 Control Circuit Open Test Status
- Ignition Coil 1-4 Control Circuit High Voltage Test Status
- Verify that DTC P0351, P0352, P0353, or P0354 is not set.
- Operate the vehicle within the conditions for running the DTC to verify the DTC does not reset. You may also operate the vehicle within the conditions that you observed from the freeze frame/failure records data.