Conditions for Running the DTC

P0335 - Engine Cranking Crankshaft Test

• DTCs P0101, P0102, and P0103 are not set.
• The starter is engaged.
• The engine air flow is greater than 3.00 g/s.
• The DTC runs continuously when the above conditions are met for greater than 0.1 s.

P0335 - Time Based Crankshaft Test

• DTC P0651 is not set.
• The engine is running.
• The starter is not engaged.
• The DTC runs continuously when the above conditions are met for greater than 0.013 s.

P0335 - Event Based Crankshaft Test

• DTCs P0335, P0336, P0641, and P0651 are not set.
• The starter is engaged.
• The engine is running.
• The DTC runs once per engine revolution.

P0336 - Crank Resynchronization Test

• DTCs P0335 and P0651 are not set.
• The engine air flow is greater than 3.00 g/s.
• The engine speed is greater than 225 RPM.
• The DTC runs continuously when the above conditions are met for greater than 0.3 s.

P0336 - Time Based Crankshaft Test

• DTC P0651 is not set.
• The engine is running.
• The starter is not engaged.
• The DTC runs continuously when the above conditions are met for greater than 0.013 s.

P0336 - Engine Start Test During Crank

• DTCs P0101, P0102, and P0103 are not set.
• The engine air flow is greater than 3.00 g/s.
• The starter is engaged.
• The DTC runs continuously when the above conditions are met for greater than 0.1 s.

P0336 - Event Based Crankshaft Test

• DTCs P0335, P0336, P0641, and P0651 are not set.
• The starter is engaged.
• The engine is running.
• The DTC runs once per engine revolution.