LEMON Manuals: Even more car manuals for everyone
Home >> Chevrolet >> 2012 >> Cruze Eco, Automatic Trans >> Repair and Diagnosis >> External Pages >> Different variant/trim >> Section 5 (Engine Controls/Fuel - 1.8L - DTC Diagnostics, Troubleshooting & Diagnosis) >> Diagnostic Information and Procedures >> DTC P0300-P0304 or P0313 (LUW) >> Repair Verification

Repair Verification

WARNING: This page is about a different variant/trim than selected.
  1. Install any components or connectors that have been removed or replaced during diagnosis.
  2. Perform any adjustment, programming or setup procedures that are required when a component or module is removed or replaced.
  3. Clear the DTCs.
  4. Turn OFF the ignition for 60 s.
  5. If the repair was related to a DTC, duplicate the conditions for running the DTC and use the freeze frame/failure records, if applicable, in order to verify the DTC does not reset. If the DTC resets or another DTC is present, refer to the Diagnostic Trouble Code (DTC) List - Vehicle .
  6. To verify that the performance of the catalyst has not been affected by the condition that set this DTC, perform the Repair Verification for DTC P0420. Refer to DTC P0420 (LUW) .