Circuit/System Description

WARNING: This page is about a different variant/trim than selected.

The engine control module (ECM) uses information from the crankshaft position sensor in order to determine when an engine misfire is occurring and uses information from the camshaft position sensor intake and camshaft position sensor exhaust sensors in order to determine which cylinder is misfiring. By monitoring variations in the crankshaft rotation speed for each cylinder, the ECM is able to detect individual misfire events. If the ECM detects a misfire rate sufficient to cause emission levels to exceed mandated standards, DTC P0300 sets. Under certain driving conditions, a misfire rate can be high enough to cause the 3-way catalyst to overheat, possibly damaging the converter. The malfunction indicator lamp (MIL) will flash ON and OFF when converter overheating, damaging conditions are present and DTC P0300 is set. DTCs P0301 - P0304 correspond to cylinders 1-4. If the ECM is able to determine that a specific cylinder is misfiring, the DTC for that cylinder will set. If the ECM detects a misfire and low fuel level, DTC P0313 is set.