Component Testing
WARNING: This page is about a different variant/trim than selected.
- Ignition OFF, disconnect the B34 Engine Coolant Temperature Sensor harness connector at the sensor.
- Test for refer to Temperature Versus Resistance (ECT)
Temperature Versus Resistance between the signal circuit terminal 1 and the low reference terminal 2.
- If the temperature versus resistance are not within the specified ranges
Replace the B34 Engine Coolant Temperature Sensor.
- If the temperature versus resistance are within the specified ranges
- If the temperature versus resistance are not within the specified ranges
- Test for infinite resistance between each terminal and the sensor housing.
- If less than infinite resistance
Replace the B34 Engine Coolant Temperature Sensor.
- If infinite resistance
- If less than infinite resistance
- All OK.