Conditions for Running the DTC
WARNING: This page is about a different variant/trim than selected.
P0068
- The engine speed is greater than 800 RPM.
- The run/crank voltage or powertrain relay voltage is greater than 6.41 V.
- The throttle actuator control system is not in reduced power mode.
- DTC P0068 runs continuously once the above conditions are met.
P1101
- DTCs P0102, P0103, P0107, P0111, P0112, P0113, P0116, P0117, P0118, P0119, P0335, P0336 are not set.
- The engine speed is between 400-7 000 RPM.
- The engine coolant temperature (ECT) Sensor is between -7 to + 125°C (19.4 to +257°F).
- The intake air temperature (IAT) Sensor is between -20 to +125°C (-4 to +257°F).
- DTC P1101 runs continuously once the above conditions are met.