Component Testing
WARNING: This page is about a different variant/trim than selected.
- Ignition OFF, disconnect the harness connector at the appropriate Q6 Camshaft Position Actuator Solenoid Valve.
- Test for 7-12 Ω between the terminals of the Q6 Camshaft Position Actuator Solenoid Valve.
- If not within the specified range, replace the Q6 Camshaft Position Actuator Solenoid Valve.
- Test for infinite resistance between each terminal and the Q6 Camshaft Position Actuator Solenoid Valve housing.
- If not the specified value, replace the Q6 Camshaft Position Actuator Solenoid Valve.