LEMON Manuals: Even more car manuals for everyone
Home >> Chevrolet >> 2012 >> Cruze Eco, Automatic Trans >> Repair and Diagnosis >> External Pages >> Different variant/trim >> Section 3 (Engine Controls/Fuel - 1.8L - Repair Instructions) >> Repair Instructions >> Fuel Level Sensor Replacement >> Installation Procedure

Installation Procedure

WARNING: This page is about a different variant/trim than selected.
    Fig 1: Fuel Sender Assembly
    GM2189327Courtesy of GENERAL MOTORS COMPANY
  1. Install the fuel sender assembly (2).
  2. Clip in the 2 fuel sender retainer pins.
  3. Connect the fuel sender assembly wiring harness plug (1).
  4. Assemble and install the fuel tank. Refer to Fuel Tank Fuel Pump Module Replacement .
scientia non olet · About LEMON Manuals